|
|
Post by frankiefoureyes on Sept 6, 2018 12:54:02 GMT -6
Are the peg holes to hold his scabbard to his back made to just break off I barely pushed it..
|
|
|
|
Post by dippergames420 on Sept 6, 2018 13:50:07 GMT -6
Unfortunately, that is a frequent defect. I've broken two Premium Trunks sheaths, which is why I don't advise pegging it in unless you know it won't break, even then I wouldn't advise it.
|
|
|
|
Post by frankiefoureyes on Sept 6, 2018 14:02:57 GMT -6
Ugh I broke both... gonna try and super glue the peg back on one.. I hope the new one doesnt have the same defect Unfortunately, that is a frequent defect. I've broken two Premium Trunks sheaths, which is why I don't advise pegging it in unless you know it won't break, even then I wouldn't advise it. |
|
|
|
Post by dippergames420 on Sept 6, 2018 15:34:25 GMT -6
Out of curiosity, which one broke or was it both?
|
|
|
|
Post by frankiefoureyes on Sept 6, 2018 15:45:34 GMT -6
Out of curiosity, which one broke or was it both? Both the og one broke of inside his back the pc just snapped off have yet to find the peg.. any tips to get it out of his back |
|
|
|
Post by dippergames420 on Sept 7, 2018 18:58:33 GMT -6
Out of curiosity, which one broke or was it both? Both the og one broke of inside his back the pc just snapped off have yet to find the peg.. any tips to get it out of his back You could possibly heat it up with a hair dryer or a heat gun, then remove the peg. Just bear in mind that heat guns may very well take less time to heat up the plastic, and with such you run a greater risk of melting the figure. |
|
